Blueprinted front wheel hub (NA/NB chassis)

If you’re running your NA or NB Miata hard on the track, you’re probably burning through front wheel bearings on a regular basis. And that means you’re losing track time or races. ART knows this, so they’ve put together these blueprinted hubs. They start off as factory hubs, but they’re carefully checked and packed with a high temperature grease. They’ll cut down your failure rate dramatically.

Sure, they’re a bit more expensive. But they’ll last a whole lot longer than stock ones, so you’ll save money in the long run.

If you’d like ARP studs, please add them to your cart. Bear in mind that you’ll need to press them in, which isn’t complicated if you have a press. 

These hubs aren’t available with ABS rings, but if your stock hubs have ABS rings you should be able to press them off of your original hubs and onto these hubs. Note that these start out as Mazda (NTN) hubs, so if the hubs on your car are aftermarket the rings may or may not be the appropriate size for these hubs. 

Nuts are included, but new dust caps (not included) are recommended.

Recommended installation is to have everything very clean, install and torque to 145 ft-lbs with a proper torque wrench, not power tools.

Sold individually – that’s one hub.